How to wind the hair on the curling

To date, the most popular tool for creating curls is electric curling. She replaced the iron rods, which previously had to be heated.

Method number 1. Cone curling iron

The device is a forceps, in which the diameter tapers towards the end. A cone-type curling iron allows you to make curls that look as natural as possible. The device has no clip fixing the tips of the strands. When using curling, use gloves with thermal protection. So you will not get a burn of the skin of the hands when you hold the curls.

Option number 1. Classic Curling

1. Comb through hair the entire length using a massage brush with natural bristles. Then separate with a comb a section of hair about 4-5 cm wide.
2. The size of curls directly depends on the size of the strand. Now lift the curl with your fingers for the end, set the curling iron with a wide part to the root area.
3. Gently wind the entire length of the strand on the device, the ends of the hair should be on the narrowed part of the cone. It is more convenient to carry out the procedure if you hold the device diagonally with respect to the head. At the same time direct the tips upwards.
4. After cheating count to 5, then gently remove the curtain. Evaluate the result, let the hair cool. Repeat with all remaining hair, changing the width of the original strand to obtain a natural curl.

Option number 2. Curling in small waves

1. Make sure the hair is dry and clean. Then comb them from the tips to the roots using a massage brush. Separate a curl of 1.5 cm. Twist the strand into a not very tight flagellum.
2. Lift the treated area of ​​hair up, holding the tip of your fingers. Bring the wide part of the conical curling to the root area from below, wind the rest of the length on the fixture.
3. Similar to the technology above, the tip of the curl should be located at the narrow part of the cone. Count to 7, then remove the instrument.Evaluate the result, carry out manipulations with each strand separately.

Method number 2. Automatic Curler

Automatic-type curling irons assume the presence of rotating spirals, which themselves twist the strands and at the exit turn out curls of different thickness and diameter. The final result depends on the temperature mode of the curling, the width of the original curl, the direction of curling, the duration of exposure. All parameters are set independently.

Waving technique (BabyLiss curling iron)

1. Connect the instrument to the mains, wait until it reaches the set temperature. Set the direction of curling and the duration of laying using a special lever.
2. Comb the whole pile, then separate the strand and once again go over it with a natural bristle massage brush. Stretch curl, open the door of the device, bring the device to the zone of the roots.
3. Close the curler, press the "Start" button. You will notice how the length of the strand is screwed onto the tool rods and hid in the instrument box. When the curtain is making a signal of completion, release the strand by opening the flap.
4. To get a salon result, choose the direction of winding correctly. There are 2 main types - “to face” and “from face”. Do not change the position so that the hair does not look chaotic.

Method number 3. Curling Corrugated

There is a tool for curling hair, which has a nozzle "corrugation". This type of curler is presented in the form of two plates, which on the inside have a zigzag convex texture. A strand is inserted between the clamps, and small waves are produced at the exit (as after weaving thin braids).

Curling Technique

1. Wash your hair with a balm conditioner. Dry the hair 100%, then comb. Separate the strand with a width equal to the length of the forceps.
2. Heat the curling iron. Put a flat curl between the two clips near the root zone. Count down to 5-10 seconds. Duration depends on how sharp the waves you need to get.
3. Then lower the curling iron below along the same strand so that there are no gaps between the treated and processed areas. Count to 10 again. Do the same thing until you reach the tips.
4. If you do not want to get a fluffy hairstyle, then walk the tongs, the corrugation only on the upper part of the hair. You can also work out individual curls, creating a gentle image.

Method number 4. Round curling iron

The round curling iron belongs to tools of classical type. The working rods are in the form of a cylinder, the device is equipped with a clip that fixes the ends of the hair. Depending on the diameter, the curling iron may have a size in the range of 10-50 mm., This affects the size of curls. The most common are curling irons, the cross section of which is 20-25 mm.

Option number 1. Fine curls by vertical curling

1. Separate with a comb a curl, the thickness of which does not exceed 5 cm. Comb the comb, lift the tip, observing a right angle with the head.
2. Without unbending the forceps, run a hot tool over the entire length of the strand. Move from the root area to the tips. When the hair gets warm, clamp the end of the strand.
3. Keep the tool upright. Twist the spinner, turning the hand to the very roots. Count down to 6 seconds, loosen the compressive force, remove the tool.

Option number 2. Horizontal curls round curls

1. First prepare the hair. Make sure they are clean and combed. Separate a curl, the width of which will be 3-4 cm.Lift it up, walk the hot tool from the roots to the tips.
2. Clamp the forceps at the end of the strand, locking it. Raise your arm so that the curling iron is horizontal. Wind the curl to the root zone from the face or towards it.
3. Count up to 10 seconds, free your hair and let it cool completely. Do not touch the hot strands so that they will not break up. After cooling, you can divide the treated area into several sections and sprinkle with varnish.

The subtleties of creating curls on the hair of different lengths

It is known that long hair is more difficult to wind than the average or short. Difficulties due to the severity and size of strands that are not sufficiently heated. On the other hand, the curl for long hair is not suitable for owners of short haircuts. Hence the need to consider the subtleties of the procedure.

Short hair

1. Choose a conical or round type curling iron with a diameter not exceeding 27 mm. An ideal variant is a tool with an indicator of 15–23 mm.
2. Separate the strands with a width of not more than 3 cm. When curling, retract from the root area by 3-5 cm.
3. To create elastic curls, grab the tip of the curl with the tool, hold the curling iron vertically or horizontally, wait 12 seconds.
4. To obtain mischievous waves, hold a strand in the root area, scroll down the curling iron to the tips gradually.

Medium hair

1. If your hair is up to the length of the blades, choose a curling iron with a diameter of 18-24 mm. Separate locks 3-5 cm wide.
2. In the process of curling keep curling on your hair for at least 10 seconds. After the procedure, roll the curl into a bagel and pin it to the root part until it cools.
3. To curls not bristling in all directions, fix the tip of the curl and wind the strand on the curling iron to the middle of the length or slightly above it.

Long hair

1. If you are a happy owner of long hair, choose tools with a diameter greater than 25 mm. The complexity of creating hair lies in a large investment of time.
2. Long curls do not warm up well, so separate the thin strands (about 2-3 cm). Screw them onto the curtain starting from the tips. The duration of fixation is 25 seconds.
3. After you create a curl, twist it into a bagel and slaughter it invisible. Lock until cool.
4. If you want to get large curls, experts advise to retreat from the roots of 10-12 cm. So the curls will look natural, fixing will last for a long time.

Precautions when working with curling

1. In order not to harm the shovel, adhere to safety rules. Do not use forceps more than 2 times a week, better less.
2. Do not immediately turn on the instrument at a high temperature in order to shorten the procedure. For weakened hair, it is recommended to set the mode to no more than 100 degrees. All the rest is suitable indicator of 200 degrees.
3. Carefully read the instructions for each method of curling. It details how to maintain the tool on the hair. Do not exceed this duration.
4. You should not try to wind strands more than 2 cm thick. After laying, they almost immediately fall off, and you waste time.
5. If you do not have curling, but there is a desire to buy it, do not chase the cheapest device. Prefer professional tongs that will keep your hair in order.
6. For large curls, it is necessary to keep the curling iron in a horizontal position.In this case, the original strands should not be too thin. To obtain pronounced spiral-shaped curls, the device is held in a vertical position.
7. Some girls practice perm not the entire length, but only the tips. You can also wind the hair, after collecting them in the tail. This style will make the image romantic.

Light curls, sexy waves, romantic curls, elastic large curls - these and other styling options can be translated into reality with the help of an ordinary hair curler. There are many forceps that allow you to curl on strands of different lengths.

Video: how to curl your hair