How to wash the resin from the clothes at home

Before proceeding with the treatment of the product from traces of resin, it is necessary to carefully prepare the clothing. Try to clean the adhesive with sharp objects (nail scissors, knife). To facilitate the task, put the clothes in the freezer and leave for a couple of hours until fully set. After that, doubt the place with the contaminated site into a fist to make the resin crack, scrape off. Such manipulations are required when cleaning clothes from traces of this kind, but it is worth being careful when handling delicate fabrics.

Practical recommendations

1. To prevent the resin from spreading beyond its borders, apply and rub baby talc without fragrances into the fabric around the stain.
2. If the soiled area is small, cover it with cleaning agents locally with a cotton swab or brush. Try not to touch the clean areas of clothing.
3. Start cleaning the product and using the composition from the edges of the spot, gradually moving to the center. Treat the thing from the wrong side with sunflower oil.

Turpentine and alcohol

Turpentine and Ammonia

Mix in a uniform mass of 1 ml. ammonia, 20 gr. corn starch, 2 ml. turpentine, mix the composition with a knife or fork. Remove the product, moisten the stain on the wrong side with olive oil so that dirt does not penetrate into the fabric. Put a piece of polyethylene on it, then spread the prepared mixture onto the outside of the stain.Cover the area with food film, leave for 1 hour. At the end of time, remove the film, wait for partial drying. Rub the resin with a toothbrush, repeat the cleaning if necessary.

Soda and tooth powder

Moisten clothes in cold water, rub the pollution with soap (concentration from 60%), leave for 2 hours. After the expiration date, rinse, proceed to the preparation of the mixture. Combine in one mass 35 gr. baking soda and 50 grams. whitening tooth powder (can be replaced with a paste). Distribute to sites with pitch, pour a little Chlorhexidine from above. The composition will begin to hiss and foam, then it must be covered with cling film and wait 20 minutes. Then you need to rinse the thing, then apply only chlorhexidine to the stain and carry out a machine / hand wash with the addition of rinse.

Solvent

The tool is not suitable for removing resin from delicate, namely thin types of fabric, because it spoils the structure. Process in a similar way clothes from dense fabrics that will withstand the effects of hard drugs. As a solvent, you can use a liquid for removing varnish and shellac, gasoline, pure acetone, white spirit.To effectively remove the adhesive, moisten the cosmetic disc in one of the suggested solutions. Apply any natural oil to the back of the stain to prevent resin from penetrating the fabric fibers. After that, blot the stain and leave for half an hour. Wash the thing in the machine with the addition of air conditioning. If the result did not bring fruit, apply the solution again.

Stain remover

A positive characteristic of this method is considered to be its universality. Industrial products are available in the form of a powder, gel, spray or soap. Depending on the type of fabric, you can choose the best option. As such, there is no general instruction, it all depends on the specific manufacturer. Read the label on the back of the bottle. The most common and effective stain removers are Eared Nanny, Antipyatin, Vanish, Faberlik, Sarma Active, Amway, Edelstar, Minutka, Ecover, Frau Schmidt. All listed products you will find in the departments of household chemicals.

Sprite

As an effective method of removing the resin, you can use carbonated drinks such as Sprite, Schweppes, Fanta, Coca-Cola and others. Pour 2 liters of drink in a basin and leave for 3-4 hours.After soaking the resin will move away from the fabric and soften, as a result of which it will not be difficult to remove. Do this with a soft toothbrush. In cases where parts of clothing that can be processed locally are soiled, it is not necessary to lower the thing into the solution as a whole.

Boric acid

To prepare the composition you need to dilute 20 ml. boric acid in 400 ml. clean water. To use the solution correctly, moisten a cosmetic tampon in it, treat the stain on the wrong side, apply vegetable oil and transfer to the outer area. Blot the tar again, do not press or rub it, so as not to aggravate the situation. Wait about an hour, rinse the item and evaluate the result. If there is no proper effect, repeat the treatment. Finish cleaning with a typewriter.

Sodium borate ("borax")

There is a second use of borax.For the preparation of an effective drug squeeze the juice from half a lemon, add 45 grams to it. sodium borate and mix well with a knife. Spread the composition on resinous traces, wait about an hour. If the product is white, you can pre-cover the contamination with peroxide solution and leave for 10 minutes.

Bleach

The method is designed for clothes of white color from natural fibers. Do not handle chlorine colored and delicate products. From the common bleach can be distinguished "Domestos", "Whiteness", "Perox". Dissolve 2 caps of the product in 1.3 liters of hot water, place the clothes and boil for 45 minutes. After the expiration date, remove with a wooden spatula or forceps, do not wring out, immediately place in a washing machine. Set the mode to 60 degrees, add the bleaching powder and 100 gr. soda (in the second compartment). After washing, dry your clothes in the fresh air away from the direct rays of the sun.

Watch out for exposure time. Dampen the area around the stain with clean ice water, such a course will not allow the resinous composition to spread, so the removal will take place without any extra effort. Do not treat with solvent silk and other delicate fabrics.

Video: check the myths about removing stains from clothes